B&R Automation X20DO8332 Module

Technical description Order number Switching delay 0→1 1→0 Switching frequency
Resistive load Inductive load Braking voltage when switching off inductive
loads Insulation voltage between channel and bus Additional functions Electrical properties
Electrical isolation Operating conditions Mounting orientation Horizontal
Vertical Installation elevation above sea level 0 to 2000 m >2000 m Degree of protection per EN 60529
Ambient conditions Temperature Operation Horizontal mounting orientation
Vertical mounting orientation Derating Starting temperature Storage Transport
Relative humidity Operation Storage Transport Mechanical properties Note
X20DO8332
X20cDO8332 <300 µs <300 µs
Max. 500 Hz See section "Switching inductive loads".
Typ. 50 VDC 500 Veff Outputs can be connected in parallel to increase the output current.
Channel isolated from bus and I/O power supply
Yes Yes No limitation Reduction of ambient temperature by 0.5°C per 100 m
IP20
-25 to 60°C -25 to 50°C See section "Derating".
-
Yes, -40°C -40 to 85°C -40 to 85°C
5 to 95%, non-condensing Up to 100%, condensing 5 to 95%, non-condensing
5 to 95%, non-condensing Order 1x terminal block X20TB12 separately.
Order 1x terminal block X20TB12 separately.
Order 1x bus module X20BM11 separately.
Order 1x bus module X20cBM11 separately.
12.5+0.2 mm
Pitch
Table 2: X20DO8332, X20cDO8332 - Technical data 1) 2)
Number of outputs x RDS(on) x Nominal output current2. For a calculation example, see section "Mechanical and electrical configuration" in the X20
system user's manual.
Derating must be observed for summation current starting at 6 A.
2.2 Status LEDs For a description of the various operating modes, see section "Additional information - Diagnostic LEDs"
in the X20 system user's manual.
Figure
6
LED r
Color Green
Status Off Single flash Blinking On Off Single flash
e
Red
e+r 1-8
Double flash Red on / Green single flash Orange
Description Module supply not connected
RESET mode
PREOPERATIONAL mode
RUN mode Module supply not connected or everything OK Warning/Error on an I/O channel. Level monitoring for digital outputs has
been triggered.
I/O supply too low Invalid firmware Output status of the corresponding digital output
X20(c)DO8332 Data sheet V 3.31