MOOG E124-204-400

SPECIFICATIONS Electrical Stroke:
From 2 inches to 100 inches
Ripple:
Less than 0.8% of full output
Zero Output:
Either end of transducer (factory set)
Output Voltage:
0 to +10 VDC (bipolar also available)
Zero Adjustment:
Nominal 2% of full stroke
Special Output:
Pulse width modulated output (0 V to +12 V)
Linearity:
Less than ±0.05% of full stroke
Temperature Range:
0°C (32°F) to 50°C (122°F)
Repeatability:
Better than ±0.02% of full stroke
Connector:
DIN 41612 C
Temperature Coefficient:
0.013% per degree C
Form Factor:
Eurocard 100 x 160 mm, 7 HP, 3 U
Frequency Response:
Typical 400 Hz for 20 inch stroke
Weight:
0.38 lb (0.17 kg)
NE124-204 Series Temposonics™ Signal Conditioner
The Temposonics™ Signal Conditioner card is designed to provide the necessary power supplies and signal conditioning to drive a range of
Temposonics™ transducers.The card is factory set to drive a specific stroke
length.Trimpots, which adjust zero and gain, are used to compensate for minor
differences between transducers of the same nominal stroke length.Transducer
position is represented by an analog voltage.The inverse of this voltage and a
pulse width modulated signal are also available.
The NE124-204 Temposonics™ Signal Conditioner card is a forward compatible replacement for the E124-204.
FEATURES ➢ ➢ ➢ ➢ ➢ ➢ ➢
Analog output Infinite resolution Absolute measurement Zero adjustment Gain control
±15 VDC supplies
PWM output
ADJUSTMENTS Zero (R17) – Adjusts null of outputs for zero transducer conditions. Used
for ‘fine’ tuning the DC analog output at full retract and full extend positions.
(Factory set – front panel access)
ORDER NUMBER NE124-204-x (consult factory)
FUNCTION SELECTION J1 Analog Output Jumper: Select ‘on’ for DC analog output at Pin-25
and Pin-32. Select ‘off’ for DC analog output on Pin-25 only. (Factory set for
Pin-25.) J2 Inverse Analog Output Jumper: Select ‘on’ for inverse analog output
at Pin-27 and Pin-31. Select ‘off’ for inverse analog output on Pin-27 only.
(Factory set for Pin-27.)
Gain (R34) – Adjusts gain to the exact output option change for a zero to
full displacement magnet movement. . Used for ‘fine’ tuning the DC analog
output at full retract and full extend positions. (Factory set – PCB mtg. only –
not accessible on front panel)