B&R Automation X20CP1684 Module

Technical description Order number X20CP1684 X20cCP1684 X20CP1685 X20CP1686X
Interface IF3 Fieldbus
POWERLINK (V2) managing or controlled node Type Type 4 8) Variant 1x RJ45 shielded
Line length Max. 100 m between 2 stations (segment length) Transfer rate
100 Mbit/s Transfer Physical layer 100BASE-TX Half-duplex Yes Full-duplex
POWERLINK mode: No / Ethernet mode: Yes Autonegotiation Yes Auto-MDI/MDIX
Yes Interface IF4 Type
USB 1.1/2.0 Variant Type A Max. output current 0.5 A Interface IF5 Type
USB 1.1/2.0 Variant Type A Max. output current 0.5 A Interface IF6 Fieldbus
X2X Link master X2X Link / X2X+ master Electrical properties Electrical isolation
Ethernet (IF2), POWERLINK (IF3) and X2X (IF6) isolated from each other, from other interfaces and from PLC
Operating conditions Mounting orientation Horizontal Yes Vertical Yes Installation elevation above sea level
0 to 2000 m No limitation >2000 m Reduction of ambient temperature by 0.5°C per 100 m
Degree of protection per EN 60529 IP20 Ambient conditions Temperature Operation
Horizontal mounting orienta-25 to 60°C tion Vertical mounting orientation
-25 to 50°C Derating See section "Derating".
Storage -40 to 70°C Transport -40 to 70°C Relative humidity Operation 5 to 95%, non-condensing Up to 100%, condensing
5 to 95%, non-condensing Storage 5 to 95%, non-condensing Transport 5 to 95%, non-condensing
Mechanical properties Note Order application memory (CompactFlash) separately
Backup battery included in delivery X20 end cover plate (right) included in delivery
12-pin X20 terminal block included in delivery Interface module slot covers included in delivery
Dimensions Width 150 mm Height 99 mm Depth 85 mm Weight 480 g 9)
Table 3: X20CP168x(X) - Technical data 1) 2) 3) 4) 5) 6) 7) 8) 9)
For details about storage health data, see Automation Help.
Multi-core support is available for X20CPnnnnX processors starting with Automation Runtime 6.5.0.
The specified values are maximum values. For examples of the exact calculation, see section "Mechanical and electrical configuration" in the X20
System user's manual.
For operation above 55°C, derating of the nominal output power of the X2X Link power supply to 5 W must be observed.
In parallel operation, it is only permitted to expect 75% of the nominal power. It is important to ensure that all power supply units operated in
parallel are switched on and off simultaneously.
The memory size for remanent variables is configurable in Automation Studio.
1 MB SRAM minus the configured remanent variables.
For additional information, see section "Communication / POWERLINK / General information / Hardware - IF/LS" in Automation Help.
The PLC was weighed with the battery and terminal block X20TB12. The CompactFlash card, interface module slot cover and X20 end cover plate
(right) were not included in the weighing.
X20(c)CP168x(X) and X20(c)CP368x(X) Data sheet V 1.57
9