Cemb TA-18/S/X/0 Vibration Sensor

www.cemb.com
ACCELEROMETER TRANSDUCER
TA-18/S
The TA-18/S transducers seismically measure absolute machine vibrations by directly fastening the vibrating part on the supports.
They provide an output signal directly proportional to the vibration of the
point on which they are fastened. This signal can subsequently be processed by a measuring channel of a CEMB “T” or “N” series device.
The TA-18/S transducers exploit the piezoelectric effect, i.e. the capability
of a material to provide a difference of potential when mechanically stressed.
In this application, a ceramic material subjected to acceleration generates
an electrical signal proportional to the stress ABSOLUTE VIBRATIONS
TECHNICAL CHARACTERISTICS GENERAL Type of measurement
seismic (absolute vibration) piezoelectric
Sensitivity
100 mV/g
Response in frequency
± 3 dB 0,5 ÷ 15000 Hz ± 10 % 2 ÷ 10000 Hz
Vibration direction
any
Dynamic range
± 50 g pk
Transverse sensitivity
<5%
ELECTRICAL Power supply
2÷10 mA - 18÷30 Vdc
Output polarization voltage
10-14 Vdc
Output impedance
< 100 ohm
Outer casing insulation
> 108 ohm
Settling time
< 2,5 sec.
AMBIENT Protection against shocks
5000 g pk
Protection against external agents
IP68
PHYSICAL Weight
90 grammi
Resonance frequency
23 kHz
Outer casing material
AISI 316-L stainless steel
Retaining screw threading
see “dimensions and threads”
Connection
MIL-C-5015 2-pin connector provided
Tightening torque
2.7 to 6.8 Nm
B A L A N C I N G
M A C H I N E S