Dynisco UPR700 Process Indicator

UPR700 Process Indicator

DYNISCO MODEL UPR700 1/4 DIN Pressure/Process Indicator with Optional Second Input
Description The UPR700 pressure/process indicator is a field configurable and programmable instrument with a choice of 350 Ohm strain gage, voltage or current
input. A display of the process variable is shown on a bright red five digit LED display, as well as a 35 segment LED bargraph. A second digital display
will capture the peak reading (selectable high or low), can be blanked, or can be used as the indicator for the optional second process variable. The
UPR700 is the perfect solution for those who would like to have melt temperature and pressure read out conveniently on one instrument.
Features
Benefits
• Strain gage, V or mA input
• 2 programmable, assignable alarms;
3rd alarm optional
• Retransmission output
• Additional analog process input, TC, RTD, V or mA (optional)
• Serial communications (optional)
• 24 Vdc transmitter power supply (optional)
• Second analog output (optional)
• Three levels of security with user defined codes
• IP65/NEMA 4X rated
• Versatile process input choice
• Alarms can be linked to first or second input
• Send information to other devices
• Display two process variables • • • • •
Send and receive information from PLCs, PCs, etc.
Power 2 and 3 wire transmitters Send second variable to another device Allow different authorization levels
Useable in harsh environments
c Specifications Performance Characteristics Power supply: 100 to 240 Vac 50/60 Hz, switching
Power consumption: 15 VA maximum Operating temperature: 0˚ to 50˚C
Storage temperature: -20˚ to +70˚ C Humidity: Maximum 85% RH non - condensing
Weight: 1.43 lbs
Inputs Primary input: Selectable between strain gage and linear via jumper
and configuration Strain gage input: 350 Ohm, 2 to 4 mV/V; excitation 10 V ±7%
Input signal: -25% to +125% full scale the Shunt calibration: With or without shunt resistor (40.0% to 100.0%)
Linear input: Selectable between 0 to 5 Vdc, 0 to 10 Vdc, 0 to 20 mA,
Auxiliary power supply (optional): 24 Vdc/1.5 W for 2 or 4 wire transmitter
Input impedance: <10 Ohm for linear current input; >165 kohm for linear voltage input
Sampling time: 50 ms typical Digital input: One input, voltage free contact closure. May be programmed for one of
following functions: a. Alarm reset b. Peak reset c. Alarm and peak reset
Secondary input (optional): J, K, L, N thermocouple, PT100 RTD
Outputs Main analog output: Selectable between 0 to 10 Vdc, -10 to +10 Vdc,
0 to 5 Vdc, 0 to 20 mA, 4 to 20 mA Optional second output: Selections same as main analog output
Output functions: Selectable as main input retransmission or secondary input retransmission
Serial Communications Protocol: Modbus/Jbus, selectable
154
Serial Interface: RS485