Ropex RES-5008 Temperature Device Control

Technical data
13
Technical data NOTE Operation of the RESISTRON® Temperature Controller RES-5008 outside of these technical
specifications can lead to loss of warranty and can cause defects.
Design
Regulator:Housing for electrical cabinet mounting Can be snapped on to TS35 top hat rail (35 mm) in accordance
with EN 60715 Basic surface: 90x75 mm; depth: 135 mm (incl. connection terminals)
Terminal:Housing for panel mounting Dimensions (W x H): 96 x 48 mm, depth: 55 mm (without plug)
Line voltage
Connected between neutral conductor and an outside conductor:
110 VAC -15%…300 VAC +10% or Connected between two outside conductors:
110 VAC -15%…480 VAC +10% CAUTION The voltage between outside conductor and earth must not exceed
300 VAC.
Power supply
Symmetrical TN or TTsystem Overvoltage category III CAUTION Operation in voltage-free system (e.g. IT system) only after checking
with ROPEX.
Line frequency
47…63 Hz, automatic frequency adjustment in this range
Current consumption (Primary current of the impulse transformer)
Imax = 5 A (ED = 100%) Imax = 25 A (ED = 20%, cycle duration 1 min) A booster must be used for higher current power requirements ( Chapter 16)
24 VDC power supply Terminals 5+7
24 VDC, Imax = 200 mA (control mode), 1 A (switch-on current) Tolerance: ±10%
SELV or PELV supplied from maximum 300VAC, Cat II
Measurement range
Secondary voltage UR: 0.4 ...120 VAC (lower voltages with MOD 01, higher
voltages with a ROPEX series resistor) Secondary current IR: 30…500 A with current transformer PEX-W4/W5 (lower
currents: Secondary cables lead through the current transformer several times,
higher currents with a load resistor) The dimensioning is made in the ROPEX application report.
Version 3
RES-5008
Page 59