Ropex UPT-6006 Temperature Controller

Temperature Controller

Technical data | 14
14 Technical data 14.1 Technical data NOTICE Risk of defects and loss of warranty when operation of the device does not
comply with technical specifications Operating the device in noncompliance with the technical specifications can cause defects and result in loss of warranty.
Comply with the technical specifications.
Device Design
Technical data
• Installation in an electrical cabinet
• Snaps onto a standard top hat rail TS35 (35 mm) pursuant to EN 50022
Dimensions
Base area 90 × 75 mm Housing depth: 113 mm Depth (with terminal strips): 135 mm
Line voltage
• Connected between the neutral conductor and an outer conductor:
110 VAC -15 %…300 VAC +10 % or
• Connected between two outer conductors
• Through July 2024:
110 VAC -15 %…415 VAC +10 %
• Beginning August 2024:
110 VAC -15 %…480 VAC +10 %
Power supply system
The voltage between the line conductor and ground shall not be more than 300
VAC.
• Balanced TN or TT system with max. 480 VAC
• Installation category III Operation in an IT system is permitted only in agreement with ROPEX. Consult
ROPEX, e-mail [email protected].
Line frequency
47…63 Hz automatic adjustment to frequencies in this range
Current consumption max.
(primary current of pulse transformer)
• Imax = 5 A (duty cycle = 100 %)
Supply voltage
• 24 VDC ±10 %, Imax = 200 mA (control mode), 1 A (switch-on current)
• Imax = 25 A (duty cycle = 20 %, cycle duration 1 min)
• SELV or PELV supplied from max. 300 VAC, Cat II
Measuring range
Connect the 24 VDC supply voltage either via the terminals 5 and 7 or via the
PROFIBUS plug at pin 2 and pin 7.
• Secondary voltage UR: 0.4…120 VAC
• Secondary current IR: 30…500 A (with current transformer PEX-W5) Refer to the application report.
VERSION 4 | 01/2025 | EN-US
CIRUS® UPT-6006
Page 81 of 96