Dynisco TPT463E-10M-6/18 Pressure Sensor

Simple Installation, Repeatability And Reliability
Performance Characteristics Combined Error:
Repeatability:
Over Pressure:
Configuration:
Bridge Resistance:
Output:
Zero Balance:
Input Voltage:
Internal Shunt Calibration (R-Cal):
Insulation Resistance:
Temperature & Mechanical Characteristics
±0.5% FSO, (Including Linearity, Repeatability & Hysteresis) ±0.2% FSO 2 x FSO or 35,000 psi
(whichever is less) Four active arm bonded Wheatstone bridge strain gage
Input: 345 Ohms minimum;
Output: 350 Ohms ±10% 3.33 mV/V ±2.0% ±10% full scale 10 Vdc recommended,
12 Vdc maximum
Transducer Diaphragm:
Maximum Diaphragm Temperature:
Zero Shift (due to temperature change):
Electronics Housing:
Maximum Temperature:
Zero Shift (due to temperature change):
Sensitivity Shift (due to temperature change):
Mounting Torque:
Standard Wetted Parts:
750°F (400°C) 25 psi/100°F maximum (45 psi/100°C) 250°F (121°C) ±0.05% full scale/°F maximum
(±0.10% full scale/°C) ±0.02% full scale/°F maximum (±0.04% full scale/°C)
500 inch/lbs. maximum Dymax® coated 15-5 PH SST
80% FSO ±1.0% 1,000 megohms at 50 Vdc
Ordering Guide for PT460E Series X PT46 X E XX X/XX XXX
Temperature Blank = No temperature sensor T = J type thermocouple Transducer Configuration
0 = Rigid stem, no flexible capillary 2 = Rigid stem with flexible capillary
3 = Rigid stem with flexible capillary and temperature sensor Pressure Range (psi)
5C = 0 - 500 7.5C = 0 - 750 1M = 0 - 1,000 1.5M = 0 - 1,500 3M = 0 - 3,000
5M = 0 - 5,000 7.5M = 0 - 7,500 10M = 0 - 10,000 15M = 0 - 15,000 20M = 0 - 20,000
30M = 0 - 30,000
Option Stem Length Blank = No flex 18” = 18”, 46 cm Flex 30” = 30”, 76 cm Flex
Snout Length 3" = 3”, 7.6 cm 6" = 6”, 15 cm 9" = 9”, 23 cm 12" = 12.5”, 32 cm
Standard mating connector Dynisco P/N 711600 or 6-pin mating connector cable assembly. Accuracy may be affected if non-standard
configurations are used. For additional options please consult factory.