Output
Current 4(0)…20 mA, 20…4(0) mA (minimum / maximum load 0 / 500 ?)
Measured value Position
Measurement parameters
Resolution 16 bit; 0.0015 % (minimum 1 µm) 1
Cycle time 0.5 ms up to 1200 mm stroke length
1.0 ms up to 2400 mm stroke length
2.0 ms up to 4800 mm stroke length
5.0 ms up to 7620 mm stroke length
Linearity 2 < ±0.01 % F.S. (minimum ±50 µm)
Repeatability < ±0.001 % F.S. (minimum ±2.5 µm) typical
Hysteresis < 4 µm typical
Temperature coefficient < 30 ppm/K typical
Operating conditions
Operating temperature ?40…+75 °C (?40…+167 °F)
Humidity 90 % relative humidity, no condensation
Ingress protection Version D, G and E: IP66 / IP67 (if properly connected by means that support IP66 / IP67
(pipe, gland, etc.))
Version N: IP66, IP67, IP68, IP69K, NEMA 4X, depending on cable gland
Shock test 100 g (single shock), IEC standard 60068-2-27
Vibration test 15 g / 10…2000 Hz, IEC standard 60068-2-6 (resonance frequencies excluded)
EMC test Electromagnetic emission according to IEC/EN 55011 +A1 Class B
Electromagnetic immunity according to IEC/EN 61000-6-2
The sensor meets the requirements of the EU directives and is marked with
Operating pressure 350 bar static (5076 psi static)
Magnet movement velocity 3 Any
Design / Material
Sensor electronics housing Stainless steel 1.4305 (AISI 303); option: Stainless steel 1.4404 (AISI 316L)
Flange See “Table 1: TH rod sensor threaded flange type references” on page 6
Sensor rod Stainless steel 1.4306 (AISI 304L); option: Stainless steel 1.4404 (AISI 316L)
Stroke length 25…7620 mm (1…300 in.)
Mechanical mounting
Mounting position Any
Mounting instruction Please consult the technical drawings and the operation manual (document number: 551513)
Electrical connection
Connection type T-Series terminal
Operating voltage +24 VDC (?15 / +20 %)
Ripple ? 0.28 VPP
Current consumption 100 mA typical
Dielectric strength 700 VDC (DC ground to machine ground)
Polarity protection Up to ?30 VDC
Overvoltage protection Up to 36 VDC
