Camozzi 60M2L040A0100 Valve

CATALOGUE > Release 8.7
MOVEMENT > Series 60 cylinders
Series 60 cylinders
MOVEMENT
1
Single and double-acting, magnetic, cushioned Standard, low friction, low temperature and tandem versions
ø 32, 40, 50, 63, 80, 100, 125mm »» In compliance with ISO 15552 standards and with
the previous DIN/ISO 6431
- VDMA 24562 standards »» Rolled stainless steel rod »» Adjustable pneumatic
cushioning »» Available special versions
TANDEM:
»» Double thrust and traction forces
LOW FRICTION:
»» Friction force reduced by over 40% The Series 60 cylinders have been designed to comply with the dimensions
laid down in the ISO 15552 standards.
A permanent magnet, mounted on the piston, enables information to be received regarding the piston position by
means of proximity switches positioned along the cylinder tube.
This cylinder series is normally equipped with adjustable end-stroke cushioning.
Moreover, these cylinders are equipped with bumpers in order to reduce the
impact of the piston as it reaches the end of the stroke.
LOW TEMPERATURE:
»» Versions for -40°C and for -50°C G VARIANT FOR DUSTY
APPLICATIONS:
»» Highly resistant to dust, cement, resin, mud, and wood residue
GENERAL DATA Type of construction
with tie-rods
Operation
double-acting, single-acting, tandem. Low friction version: double-acting only.
Materials
standard: AL end-blocks and piston, rolled stainless steel AISI 420B rod, anodized AL tube,
zinc-plated steel tie-rods and tie-rod nuts, PU seals;
low friction: standard materials with NBR piston seals and NBR rod seal (FKM rod seal on request)
low temperature: standard materials with chrome plated stainless steel AISI 420B rod, brass rod scraper ring,
stainless steel AISI 303 nuts, stainless steel AISI 420B tie-rods, PU piston seals and NBR rod seal
Type of mounting
with tie-rods, with front / rear flange, foot mounting, with centre / front / rear / swivel trunnion
Strokes min - max
10 ÷ 2500 mm
Operating temperature standard and low friction: 0°C ÷ 80°C (with dry air - 20°C)
low temperature (-40°C version): -40°C ÷ 60°C (with dry air -40°C) low temperature (-50°C version): -50°C ÷ 60°C (with dry air -50°C)
Operating pressure
1 ÷ 10 bar (standard and low temperature); 0,1 ÷ 10 bar (low friction)
Speed
10 ÷ 1000 mm/sec, no load (standard and low temperature); 5 ÷ 1000 mm/sec, no load (low friction)
Fluid
filtered air, without lubrication. For standard versions only: if lubricated air is used, it is recommended to use oil ISOVG32. Once
applied the lubrication should never be interrupted.
Products designed for industrial applications.
General terms and conditions for sale are available on www.camozzi.com.
1/1.20.01