B&R Automation X67AI1323 X67 Analog Input Module

Technical description Order number Input filter Cutoff frequency Slope Sensor power supply
Voltage Voltage drop for short-circuit protection at 500 mA Summation current
Short-circuit proof Electrical properties Electrical isolation Operating conditions
Mounting orientation Any Installation elevation above sea level 0 to 2000 m
>2000 m Degree of protection per EN 60529 Ambient conditions Temperature
Operation Derating Storage Transport Mechanical properties Dimensions Width
Height Depth Weight Torque for connections M8 M12
X67AI1323 1 kHz 40 dB I/O power supply minus voltage drop for short-circuit protection
Max. 2 VDC Max. 0.5 A Yes Channel isolated from bus Channel not isolated from channel
Yes No limitation Reduction of ambient temperature by 0.5°C per 100 m IP67
-25 to 60°C -40 to 85°C -40 to 85°C
53 mm 85 mm 42 mm 190 g Max. 0.4 Nm Max. 0.6 Nm
Table 2: X67AI1323 - Technical data 1) 2) 3)
The power consumption of the sensors connected to the module is not permitted to exceed 12 W.
Based on the current measured value.
Based on the entire measurement range.
2.2 LED status indicators Figure
Status indicator 1:
Left: Green, Right: Red
Status indicator 2:
Left: Green, Right: Red
X67AI1323 Data sheet 3.20
LED Color/Status Description Status indicator 1: Status indicator for X2X Link
Left/Right Green (left) Red (right) Description Off Off No power supply via X2X Link
On Off X2X Link supplied, communication OK Off On X2X Link supplied but no X2X Link communication
On On
PREOPERATIONAL: X2X Link supplied, module not initialized I/O LEDs: Status indicator for the corresponding analog input
1-4 Color Status Description Green On The A/D converter is running.
Blinking Input signal overflow or underflow Off Module not in mode RUN Status indicator 2: Status indicator for module functionality
Left Color Status Description Green Off No power to module Single flash Mode RESET
Blinking Mode PREOPERATIONAL On Mode RUN Right Color Status Description Red
Off Module not supplied with power or everything OK On Error or reset state
Single flash Warning/Error on an I/O channel.
Overflow or underflow of the analog inputs.
Double flash Supply voltage not within the valid range
5