ELB 5909-3-0120 Bistable Change-over Contact

E.L.B. Füllstandsgeräte Bundschuh GmbH & Co. KG - An der Hartbrücke 6 - D-64625 Bensheim - Phone:+49.6251-84620 Fax:+49.6251-846272
Web: www.elb-bensheim.de e-mail: [email protected]
BK-390 for bypass-tubes Mounting and Start-up Instructions
Bistable change-over contact
Safety Instructions The precondition for flawless, safe operation of the change-over contacts is appropriate transport,
storage, assembly, professional installation and start-up, proper use and maintenance.
These activities may only be performed by persons, who have the necessary expertise and qualifications.
The relevant safety regulations for the construction and operation of electrical systems must be
observed. If information contained in these instructions should prove to be inadequate in any way,
please contact the manufacturer.
Function The BK-390 is a magnetically-operated changeover switch that permanently changes its electric
switching status due to a switching magnet passing by (float/weight) depending on the direction of
movement. The switching status is shown in the status window of the housing cover. PASSING UNDER
=BLACK, PASSING OVER=WHITE. After the housing cover has been opened, the switching status can be
pre-set manually by turning the display wheel (BLACK/WHITE): turn clockwise “PASSING OVER”, turn
anti-clockwise “PASSING UNDER”.
Application For mounting on the side of bypass tubes. The number and position of the changeover contacts can be
chosen at random.
Mounting Mount the switch with pipe clip parallel to the bypass tube at the desired position. The cable connection
must point downwards. Only use suitable E.L.B. floats. The “O” marking on the float must point
upwards. Do not install any magnetic materials near the switch. Minimum distance to other changeover
contacts > 40 mm. Using tubes with an outer diameter of 32-34-40 mm may cause a blockage of the
float. In the event of such behaviour, please increase the distance between contact and pipe. (Plastic
spacers for example).
Electrical connections Open the housing cover and make the electrical connections in a de-energised state. Do not exceed the
maximum electrical values (see technical data). Close the housing cover.
Maintenance/servicing The BK-390 does not require any special servicing, over and above the general
inspection/functional check of the electrical system.
Technical data Connection, maximum values Degree of protection IP 65
EN 60529 Wire cross-section Max. 1.5 mm2
Material Housing
Polycarbonate
Fastening
V2A clips
Operating
- 20°C to + 70°C temperature Switching point > 40 mm distance Switching hysteresis approx. 10-15 mm
Screw fitting Cable connection
PA
Silver contact
Gold contact
Switching voltage
24...250 V AC/DC
Switching voltage 5...250 V AC/DC
Switching current
20 mA...6A AC/DC
Switching current 1 mA...0.3 A AC/DC
Switching power
Min. 2 VA/W Max. 500 VA, 60 W
Switching power
Version 29/06/2017
Min. 5 mW Max. 25 VA, 3 W
Errors and changes reserved
Pages: 1 of 1