Greisinger GMR110 Resistive Material-Moisture Measuring Device

Resistive material moisture measuring device with integrated measuring needles

GENERAL:

Compact and robust measuring device for fast evaluation of material moisture in firewood, timber, flake board, inlay, plaster, cement and lots more. A suitable characteristic is selected with help of material table on the rear side of the device before measuring. The material is contacted by pressing the measuring needles into it. The measured value is displayed only a short time afterwards. The device is especially designed for precise firewood and timber measurements, however, a lot of additional building materials can be rated.

• Material tables on rear side of device
• Integrated, exchangeable measuring needles
• Moisture rating (wet / dry) via bar graph
• Display of material moisture or water content
• Integrated temperature compensation
• Characteristic curve display

SPECIFICATIONS:

Measuring principle:
resistive material moisture measurement acc. to DIN EN 13183
Characteristic curves:
3 different wood groups (h.01, h.02, h.03) for a total of 130 wood types and 8 different building material curves (c.01, c.02, c.03, c.04, c.05, c.06, c.07, c.08)
Measuring range:
0.0 ... 100% material moisture (depends on selected characteristics)
Moisture rating:
in 6 steps (wet ... dry)
Resolution:
0.1% (<20%), 1% (> 20%)
Accuracy (at nominal temperature = 25 ° C)
Wood:
± 0.2% material moisture (Deviation to wood characteristic curve in range 6 ... 20%)
Building materials:
± 0.2% material moisture (deviation to corresponding characteristic curve)
Scope of supply:
device, 2 needle protection caps, battery, calibration protocol, manual