The SKF advanced hydraulic spindles TMHS 75 and TMHS 100 generate a high pulling force with very little effort compared to the standard mechanical spindles. They dramatically reduce the time needed to dismount a bearing or other component. The spindles are equipped with integrated hydraulic pumps for force generation. Maximum pulling forces are limited by special safety valves and the hydraulic oil will remain inside the pump.
Integrated hydraulic cylinder, pump and spindle - no separate pump is requiredSafety valve helps prevent overloading the spindle and the puller in case excessive force is appliedSpring-loaded centre point in the nosepiece allows easy centring of the puller on the shaft without damaging shaft centre pointHand lever with ergonomic grip can be rotated 360°Hardened and chrome plated piston with spring return functionExtension pieces included allows easy adaptation for the required pulling length Spare parts
DesignationDesciptionSuitable forTMHS 5TSet containing extension pieces 50 and 100 mm and the nosepieceTMHS 75TMHS 8TSet containing extension pieces 50, 100 and 150 mm and the nosepieceTMHS 100TMHS 100-1
Advanced hydraulic spindle, 100 kN, spindle onlyTMHS 100 Technical data
DesignationTMHS 75TMHS 100Contents1 × hydraulic spindle
1 × hydraulic spindle
2 × extension pieces; 50 and 100 mm (2.0 and 3.9 in.)
3 × extension pieces; 50, 100 and 150 mm (2.0, 3.9 and 5.9 in.)
1 × nosepiece
1 × nosepiece
Maximum withdrawal force
75 kN (8,4 ton US)
100 kN (11.2 ton US)
Piston stroke
75 mm (3.0 in.)
80 mm (3.1 in.)
Body thread
UN 11/4 × 12
UN 11/2 × 16
Nose piece diameter
35 mm (1.4 in.)
30 mm (1.2 in.)
Maximum reach
229 mm (9.0 in.)
390 mm (15.4 in.)
Weight
2,7 kg (6.0 lb)
4,5 kg (10.0 lb) SKF force generator selection
PullerMechanicalspindleTMHS 75TMHS 100TMMA 60
X
TMMA 80X
O
TMMA 120
O
TMMA 75H
X
TMMA 100H
X
TMMA 75H/SET
X
TMMA 100H/SET
X
TMBS 50E
X
TMBS 100E
X
TMBS 150E
X
TMHC 110E
X
TMHP 10E
X
X = Supplied standard with puller
O = Optional accessory for puller
