Ropex RES-5012 Temperature Controller

Temperature Controller

Technical data
10 !
Technical data Operation of the temperature controller outside of these technical specifications results in loss of
warranty and can cause defects.
Type of construction
Housing for installation in an electrical cabinet Snaps onto a standard top hat rail (TS35 rail, 35 mm) acc. to DIN EN 50022
Dimensions: 90 x 75 mm; depth: 135 mm (incl. terminals)
Line voltage
Connected between neutral conductor and one line conductor:
110 VAC -15%…300 VAC +10% or Connected between two line conductors:
until 01/2021: 110 VAC -15%…415 VAC +10% as from 02/2021: 110 VAC -15%…480 VAC1 +10%
!
Power supply system
The voltage between the line conductor and ground must not be more than 300 VAC.
Balanced TN or TT system Installation category III
!
Operation in potential-free systems (e.g. an IT system) is only permitted after consultation with ROPEX.
Line frequency
47…63 Hz, automatic adjustment to frequencies in this range
Current consumption (primary current of impulse transformer)
Imax = 5 A (duty cycle = 100%) Imax = 25 A (duty cycle = 20%, cycle duration 1 min)
24 VDC supply voltage Terminals 5+7
24 VDC, Imax = 200 mA (control mode), 1 A (switch-on current) Tolerance: ±10%
SELV or PELV supplied from max. 300 VAC, Cat II
Measuring range
Secondary voltage UR:
0.4…120 VAC Secondary current IR:
30…500 A (with PEX-W4/-W5 current transformer) ROPEX Application Report
EtherCAT® interface
2 Ethernet switch ports RJ45 Wiring: IEC 61784-5-3 Data transfer rate: 100 Mbit/s
Data transport layer: Ethernet II, IEEE 802.3 Addressing: automatic by means of topology or rotary coding switch
Version 6
RES-5012
Page 60