B&R Automation X20DO9332 Module

Technical description Order number Electrical properties Electrical isolation
X20DO9322
X20cDO9322
Channel isolated from bus Channel not isolated from channel and I/O power supply
Operating conditions Mounting orientation Horizontal Vertical Installation elevation above sea level
0 to 2000 m >2000 m Degree of protection per EN 60529 Ambient conditions
Temperature Operation Horizontal mounting orientation Vertical mounting orientation
Derating Starting temperature Storage Transport Relative humidity Operation
Storage Transport Mechanical properties Note
Yes Yes No limitation Reduction of ambient temperature by 0.5°C per 100 m
IP20
-25 to 60°C -25 to 50°C See section "Derating".
-
Yes, -40°C -40 to 85°C -40 to 85°C
5 to 95%, non-condensing Up to 100%, condensing 5 to 95%, non-condensing
5 to 95%, non-condensing Order 1x terminal block X20TB12 separately.
Order 1x terminal block X20TB12 separately.
Order 1x bus module X20BM11 separately.
Order 1x bus module X20cBM11 separately.
12.5+0.2 mm
Pitch
Table 2: X20DO9322, X20cDO9322 - Technical data 1) 2)
Number of outputs x RDS(on) x Nominal output current2. For a calculation example, see section "Mechanical and electrical configuration" in the X20
system user's manual.
At loads ≤ 1 kΩ
2.2 Status LEDs For a description of the various operating modes, see section "Additional information - Diagnostic LEDs"
in the X20 system user's manual.
Figure
LED r
Color Green
Status Off Single flash Blinking On Off Single flash
e
Red
e+r 1 - 12
Red on / Green single flash Orange
Description Module supply not connected
RESET mode
PREOPERATIONAL mode
RUN mode Module supply not connected or everything OK Warning/Error on an I/O channel. Level monitoring for digital outputs has
been triggered.
Invalid firmware Output status of the corresponding digital output
X20 DO 9322
2.3 Pinout
6
r e 1 2 3 4 5 6 7 8 9 10 11 12
DO 1
DO 2
DO 3
DO 4
DO 5
DO 6
DO 7
DO 8
DO 9
DO 10
DO 11
DO 12
X20(c)DO9322 Data sheet V 3.22